FT6336U::FT6336U(int8_t sda, int8_t scl, uint8_t rst_n, uint8_t int_n)

[Zhentao-Lin]

I use ESP32S3 and the code configuration is as follows.

#define I2C_SDA 2
#define I2C_SCL 1
#define RST_N_PIN -1
#define INT_N_PIN -1
FT6336U ft6336u(I2C_SDA, I2C_SCL, RST_N_PIN, INT_N_PIN);

When I looked at the serial port, after each reset, the serial port printed the following, of course, ft6336 is working normally.
E (16) gpio: gpio_set_level(226): GPIO output gpio_num error
E (26) gpio: gpio_set_level(226): GPIO output gpio_num error

I checked the FT6336U.cpp file. The problem is with the function digitalWrite(rst n, X).
It is located on lines 44 and 46.
I printed the values for rst_n and int_n and found that they were both 255, not -1.
So. I submit feedback to you.

[pistojim]

at STM32f103 needs only : FT6336U ft6336u(RST_N_PIN, INT_N_PIN);

[asasaki-shiftall]

This library needs to set the REAL gpio num for RST_N and INT_N. It means I assume the circuit will connect RST_N and INT_N to FT6336U.
But I did not write error handling. So, I do not guarantee that it will work properly if you don't set RST_N pin and INT_N pin.

[Davi512]

I use ESP32S3 and the code configuration is as follows.

#define I2C_SDA 2

#define I2C_SCL 1

#define RST_N_PIN -1

#define INT_N_PIN -1

FT6336U ft6336u(I2C_SDA, I2C_SCL, RST_N_PIN, INT_N_PIN);

When I looked at the serial port, after each reset, the serial port printed the following, of course, ft6336 is working normally.

E (16) gpio: gpio_set_level(226): GPIO output gpio_num error

E (26) gpio: gpio_set_level(226): GPIO output gpio_num error

I checked the FT6336U.cpp file. The problem is with the function digitalWrite(rst n, X).

It is located on lines 44 and 46.

I printed the values for rst_n and int_n and found that they were both 255, not -1.

So. I submit feedback to you.

It work only on SDA and SCL
Pins?